Removing The Front Cover - Sentiotec Is1-Serie Montage- Und Gebrauchsanweisung

Installation instructions, only for experts

5.1. Removing the front cover

The front cover must be removed to mount the controller on the wall. To do this,
use a flat screwdriver.
● Insert the screwdriver into the hole provided at the bottom edge of the control
unit.
● The cover is held on by a clip. Press this inwards carefully until the cover
loosens.
● Now remove the cover from the control unit.
Once the control module has been mounted on the wall, replace the cover.
● First fit the upper edge of the cover into the control unit housing.
● Then press the bottom against the housing until the cover clicks into place
again.
Downloaded from www.Manualslib.com
WORLD OF WELLNESS
manuals search engine
p. 12/22