Preparing For Recess Mounting; Preparing The Housing - Sentiotec Is1-Serie Montage- Und Gebrauchsanweisung

Installation instructions, only for experts

4.2. Preparing for recess mounting

Mounting the control unit in a recess requires a cut-out section.
● Cut-out section size: 160 mm x 102 mm
● Mounting depth: 39.5 mm
► Ensure that the control unit

4.3. Preparing the housing

● Remove the four screws in the housing 1.
● Take the cover 2 off the control unit.
● Loosen the strain reliefs 3.
Downloaded from www.Manualslib.com
has sufficient rear ventilation!
Work on the housing must only be carried out using a standard screw-
driver. Using a cordless screwdriver may cause irreparable damage to
the housing.
WORLD OF WELLNESS
manuals search engine
1
2
p. 9/22
R=5 mm
3
EN