Honda HF2317 Übersetzung Der Originalbetriebsanleitung, Gebrauchsanleitung Seite 7

First connect the red wire (5) to the positive pole (+) and then the
black wire (6) to the negative pole (–), using the screws supplied
as shown. Apply silicone grease to the terminals and check that the
protective cap for the red wire (5) is in place.
IMPORTANT
To prevent the safety device in the electronic
circuit board from cutting in, never start the engine until the battery
is fully charged!
WARNING!
Battery acid is corrosive and polluting. Wear
protective gloves when handling the battery and dispose of
the battery in accordance with the regulations in force.
IMPORTANT
Use ONLY the specific battery mod. CNB
31500-VK1-810-M1.
3.2 ASSEMBLING THE GRASS CATCHER
A) Join the upper part of the frame (1) to the front component (2)
using the supplied screws and nuts (3) as
shown. Fit the two rubber caps (4) into the
holes in the tube of front frame (2).
HF2•••HT•
B) Before fully tightening the nuts (3),
insert the two supports (5) between the
upper chassis plates (1), with the rollers
facing inwards, and secure them with
screws and nuts (6); then tighten the
nuts (3).
C-D) Mount the two side elements (7), using screws and nuts (8
and 9) as shown. Fit the two rubber caps (10) into the holes of the
two side elements (7)
E) Insert the assembled frame in the canvas cover (11) making sure
it is correctly positioned on the base perimeter. Hook the plastic
profiles (12) onto the frame tubes with the aid of a screw-driver (13).
HF2•••HB• HF2•••HM•
F) Place the plate (14) between the
canvas and the lower part of the chassis
right element (7a) and line up the holes.
F) Attach the stiffening bar (15) under the
frame using the screws and nuts (16) and
keeping the flat part turned towards the
canvas.
G) Mount the cover (17) and fasten it to
the upper part of the frame (1) with the six
screws (18).
HF2•••HB• HF2•••HM•
H) Insert the emptying lever (19) in its
position and put in the limit stop screw
(20) with its nut (21).
3.3 ASSEMBLING THE GRASS CATCHER BRACKETS
Fit the two brackets (1) on the rear plate
(2), using for each bracket three screws
(3) which are supplied, as shown, with-
out fully tightening the nuts (4).
The brackets (1) must be mounted in
a way that the fins (1a) point inwards.
Fasten to the supports the upper part
(5) of the grass catcher frame e and
centre it up with the rear plate (2).
Adjust the position of both brackets (1)
in relation to the slot (6) so that, by turn-
ing the grass catcher frame, the pin (7)
slots in place (8).
Make sure again that the frame (5) is
well centered in relation to the rear
plate (2) and that the rotation move-
ment takes place regularly, as indicated
above, then tighten the screws fully (3) and the fastening (4) nuts.
7 EN