Identification Of Main Components; Unpacking And Assembly - Honda HF2317 Übersetzung Der Originalbetriebsanleitung, Gebrauchsanleitung

HOW TO RECOGNIZE YOUR MACHINE
Preparation, use and maintenance of a range of machines with many
differing features are described in this manual. It is therefore impor-
tant to clearly identify your machine's model in order to following all
of the information regarding it.
Your machine's model is indicated on the "identification label" in point
4 and is composed of a series of letters and numbers.
In the following pages of this manual, the model or models to which
operations refer are indicated beforehand. The absence of any indi-
cation means it is valid for all models.

2.2 IDENTIFICATION OF MAIN COMPONENTS

The machine is composed of a series of main components that have
the following functions:
1. Cutting-means assembly: this is the casing that houses the
rotating cutting means.
2. Cutting means: these are what cut the grass; the fins at the
ends help convey the cut grass towards the discharge chute.
3. Discharge chute: this is the part connecting the cutting-
means assembly to the grass catcher.
4. Grass catcher: as well as collecting the grass cuttings, this is
also a safety element that stops any objects drawn up by the
cutting means from being hurled away from the machine.
5. Rear discharge guard (available upon request): this can be
fitted in place of the grass catcher and prevents objects from
being drawn up by the cutting means and hurled away from the
machine.
6. Engine: this moves the cutting means and the wheels drive.
7. Battery: provides the energy for starting the engine. Its specifica-
tions and regulations for use are described in a specific manual.
8. Driver seat: this is where the machine operator sits. It has a
sensor connected to safety devices for detecting the presence
of the operator.
9. Regulation and safety labels: give reminders on the main
regulations for working safely, each of which is explained in
chapter 1.
10. Inspection hatch: for access to make several adjustments.
EN 6

3. UNPACKING AND ASSEMBLY

For storage and transport purposes, some components of the ma-
chine are not installed in the factory and have to be assembled after
unpacking. Follow the instructions below.
WARNING!
Unpacking and completing the assembly
should be done on a flat and stable surface, with enough
space for moving the machine and its packaging, always mak-
ing use of suitable equipment. Do not use the machine until all
the indications provided in the "ASSEMBLY" section have been
carried out.
3.1 ACTIVATING AND CONNECTING THE BATTERY
IMPORTANT
DRY CHARGE BATTERY!
The battery (1) is housed behind the engine and secured with a
strap (2).
Unfasten the strap (2) and
remove the battery.
Remove the sealing tape
and pour in the electro-
lytic solution (3) (diluted
sulphuric acid not sup-
plied: specific weight
1.280, distributing it
evenly among the six ele-
ments until it reaches the
"UPPER LEVEL" marking
on the battery.
IMPORTANT
T h e
electrolyte solution
must not exceed
30°C/86°F during the
filling process.
Leave the battery stand-
ing for at least half an hour
after filling. The electro-
lyte solution level should
drop. Pour the electrolyte
solution again up to the
"UPPER LEVEL" refer-
ence mark.
It is important for the level
to stay always between
the "UPPER LEVEL" and
"LOWER LEVEL" refer-
ence marks on the bat-
tery.
Place and tighten the six
caps (4) provided and
charge the battery.
IMPORTANT
After
activating the battery, always charge the battery completely with
the help of your dealer, who will have all the right equipment. The
battery charger is NOT able to charge the battery for the first time
after activation.