Troubleshooting; Replacing The Lamp - JUNO JB121D0 Benutzerinformation

When the cleaning is completed, install
the glass panels and the oven door.
Make sure that you put the glass panels
(A and B) back in the correct sequence.
Check for the symbol / printing on the side
of the glass panel, each of the glass
panels looks different to make the
disassembly and assembly easier.
When installed correctly the door trim
clicks.
A B
Make sure that you install the middle
panel of glass in the seats correctly.

TROUBLESHOOTING

WARNING! Refer to Safety
chapters.
What to do if...
Problem
You cannot activate or oper‐
ate the oven.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.

Replacing the lamp

1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The back lamp
1. Turn the lamp glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
Possible cause
The oven is not connected
to an electrical supply or it is
connected incorrectly.
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
WARNING! Risk of electric
shock.
The lamp can be hot.
CAUTION! Always hold the
halogen lamp with a cloth to
prevent grease residue from
burning on the lamp.
Remedy
Check if the oven is correct‐
ly connected to the electrical
supply (refer to the connec‐
tion diagram if available).
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
33
A
B