Automatic Programmes - JUNO JB121D0 Benutzerinformation

14
When the Time Delay function
is turned on, the display shows
a symbol of the heating
function,
The dot shows which clock
function is on in the Clock /
residual heat display.
Setting: Set + Go
You can use the Set + Go function only
when the Duration is set.
1. Set a heating function and
temperature.
2. Set the Duration.
3. Press again and again until the
display shows flashing
4. Press to set the Set + Go function.
The display shows
indicator. This indicator shows which clock
function is activated.
5. Press a sensor field (apart from ON /
OFF) to start the Set + Go function.
Setting: Minute Minder
1. Press .

AUTOMATIC PROGRAMMES

WARNING! Refer to Safety
chapters.
There are 20 automatic programmes. Use
an automatic programme or recipe when
you do not have the knowledge or
experience on how to prepare a dish. The
display shows the default cooking times
for all automatic programmes.
Automatic programmes
Programme
1 ROAST BEEF
2 ROAST PORK
3 ROAST VEAL
with a dot and .
.
and with an
The display shows flashing
2. Press to switch between options.
First you set the seconds, then the
minutes and the hours.
3. Press or
Minder and
4. Press or the Minute Minder starts
automatically after 5 seconds.
When the set time ends, the signal sounds
for 2 minutes and the display shows
flashing 00:00 and
5. Press a sensor field to stop the signal.
Setting: Count Up Timer
1. To reset the Count Up Timer press:
again and again until display shows
flashing .
2. Press and hold:
shows "00:00" the Count Up Timer
starts to count up again.
Programme
4 ROAST LAMB
5 ROAST GAME
6 CHICKEN, WHOLE
7 WHOLE FISH
8 PIZZA
9 QUICHE LORRAINE
10 LEMON SPONGE CAKE
11 CHEESE CAKE
12 ROLLS
13 FARMER BREAD
and "00".
to set the Minute
to confirm.
.
. When the display