Electrical Connection - JUNO JB121D0 Benutzerinformation

4
• Install the appliance in a safe and
suitable place that meets installation
requirements.
• Keep the minimum distance from other
appliances and units.
• Before mounting the appliance, check if
the oven door opens without restraint. If
not the oven has to be lifted.
• The appliance is equipped with an
electric cooling system. It must be
operated with the electric power supply.
Cabinet minimum
height (Cabinet un‐
der the worktop mini‐
mum height)
Cabinet width
Cabinet depth
Height of the front of
the appliance
Height of the back of
the appliance
Width of the front of
the appliance
Width of the back of
the appliance
Depth of the appli‐
ance
Built in depth of the
appliance
Depth with open
door
Ventilation opening
minimum size. Open‐
ing placed on the
bottom rear side
Mains supply cable
length. Cable is
placed in the right
corner of the back
side
Mounting screws

Electrical connection

• All electrical connections should be
• The appliance must be earthed.
• Make sure that the parameters on the
• Always use a correctly installed
590 (600) mm
• Do not use multi-plug adapters and
• Make sure not to cause damage to the
560 mm
550 (550) mm
594 mm
• Do not let mains cables touch or come
576 mm
• The shock protection of live and
595 mm
559 mm
• Connect the mains plug to the mains
569 mm
548 mm
• If the mains socket is loose, do not
1022 mm
• Do not pull the mains cable to
560x20 mm
• Use only correct isolation devices: line
1500 mm • The electrical installation must have an
4x25 mm
• This appliance is supplied with a main
WARNING! Risk of fire and
electric shock.
made by a qualified electrician.
rating plate are compatible with the
electrical ratings of the mains power
supply.
shockproof socket.
extension cables.
mains plug and to the mains cable.
Should the mains cable need to be
replaced, this must be carried out by
our Authorised Service Centre.
near the appliance door or the niche
below the appliance, especially when it
operates or the door is hot.
insulated parts must be fastened in
such a way that it cannot be removed
without tools.
socket only at the end of the
installation. Make sure that there is
access to the mains plug after the
installation.
connect the mains plug.
disconnect the appliance. Always pull
the mains plug.
protecting cut-outs, fuses (screw type
fuses removed from the holder), earth
leakage trips and contactors.
isolation device which lets you
disconnect the appliance from the
mains at all poles. The isolation device
must have a contact opening width of
minimum 3 mm.
plug and a main cable.