Troubleshooting; Service Data - JUNO JH084C1 Benutzerinformation

Turn off the oven. Wait until
the oven is cold.
Back lamp
Step 1 Turn the glass cover to remove it.
Step 2 Clean the glass cover.
Step 3 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4 Install the glass cover.

TROUBLESHOOTING

WARNING! Refer to Safety
chapters.
What to do if...
In any cases not included in this table
please contact with an Authorised Service
Centre.
Problem
The oven does not
heat up.
The door gasket is
damaged.
The display shows
"12.00".
The water leaks out
of the cavity em‐
bossment.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
Before you replace the lamp:
Disconnect the oven from
the mains.
Check if...
The fuse is blown.
Do not use the
oven. Contact an
Authorised Service
Centre.
There was a power
cut. Set the time of
day.
There is too much
water in the cavity
embossment.
Put a cloth on the bottom of
Problem
Unsatisfying cook‐
ing performance of
the function: True
Fan Cooking
PLUS .
The lamp does not
work.

Service data

If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the oven cavity. Do
not remove the rating plate from the oven
cavity.
.........................................
.........................................
.........................................
29
the cavity.
Check if...
You filled the cavity
embossment with
water.
The lamp is burnt
out.