Troubleshooting - JUNO JB070A2 Benutzerinformation

Step 8
If the door is installed correctly, you will hear a click when closing the latches.
When installed correctly the door trim clicks.
Make sure that you install the internal glass panel
in the seats correctly.
10.5 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Step 1
Turn off the oven. Wait until the
oven is cold.
Back lamp
Step 1
Turn the glass cover to remove it.
Step 2
Clean the glass cover.
Step 3
Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4
Install the glass cover.

11. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
11.1 What to do if...
In any cases not included in this table please
contact with an Authorised Service Centre.
After cleaning, install the glass panel and the oven door.
Before you replace the lamp:
Step 2
Disconnect the oven from the
mains.
Put a cloth on the bottom of the
Problem
The oven does not
heat up.
The door gasket is
damaged.
The lamp does not
work.
A
Step 3
cavity.
Check if...
The fuse is blown.
Do not use the oven.
Contact an Authorised
Service Centre.
The lamp is burnt out.
ENGLISH 17