Operation - Jackle JESS WELDING maxiMIG 250 Betriebsanleitung

maxiMIG 250/300

7 Operation

NOTICE
• Only qualified personnel are permitted to perform work on the device or system.
7.1 Control elements
7.1.1 maxiMIG 250
Fig. 5
A
B
Tab. 3
Pos.
(A)
(B)
(C)
(D)
(E)
(F)
(G)
BA-0005 • 2020-10-19
Front view of maxiMIG 250
Welding grade switch C
D
Wire feeder speed controller
G
F
E
D
C
maxiMIG 250 control elements
Description
Welding grade switch, 12 grades
For continuous adjustment of the required wire feeder speed between 1.0 and 24 m/min.
The spot time can be adjusted between 0.5 seconds and 10 seconds. For normal welding
operation, the knob must be in position "0" (turned to the left stop).
Main switch
• Position "0": switches the machine off.
• Position "1": switches the machine on.
Central connection for welding torch cable assembly.
Temperature fault light. Lights up to indicate thermal overload of the machine. The welding
process can no longer be started using the torch trigger. If the ventilator is running, the
machine will ready for operation after approximately 5 minutes.
maxiMIG 250 nameplate. Contains the technical specification of the machine.
Spot-time control dial E
F
Main switch
G maxiMIG 250 nameplate
7 Operation
Central connection
Temperature fault light
A
B
EN - 9