Jackle JESS WELDING maxiMIG 250 Betriebsanleitung Seite 39

10 Appendix
Tab. 7
Pos.
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
EN - 16
Internal replacement parts for maxiMIG 250/300
Name
Rectifier, 6 plates, 4 diodes (maxiMIG 250)
Rectifier, 6 plates, 6 diodes (maxiMIG 300)
Ventilator 130 mm, 230 V
Thermal switch 90 °C (normally open switch), inscription in black 445.080.004
Thermal switch 50 °C (normally close switch), inscription in red
Cable gland M20 × 1.5
Counternut M20 × 1.5
Solenoid valve NW 2.5/42 V, G 1/8 I
Gas hose 1.5 m
Welding transformer maxiMIG 250 with switch
Welding transformer maxiMIG 300 with switch
Thermal switch 160 °C (normally open switch) for welding
transformer
Wire feeder motor with 4-roll wire drive and 1 clamp lever
Single wire feeder motor
Wire feed roller 0.8/1.0 mm for steel - 30 mm
Wire feed roller 1.0/1.2 mm for steel - 30 mm
Wire feed roller 1.0/1.2 mm for aluminium - 30 mm
Complete housing
Steering castor 140 mm
Fixed castor 140 mm
2
Mains cable 4 × 2.5 mm , 5 m with plug
Swissfeed wire-holding arbor
Nut for Swissfeed wire-holding arbor
Cylinder-supporting chain, 24 links
Choke, complete with resistor and connection cable
Mains contactor DL 4K-14, 42 V
Control transformer 230/400-42 V, 92 VA
Control board MS 20 - 2 (maxiMIG 250)
Control board MS 20 - 6 (maxiMIG 300)
100 k burn-back potentiometer, complete (maxiMIG 300)
maxiMIG 250/300
Item no.
461.200.003
461.200.016
450.130.005
445.050.005
420.700.001
420.700.002
465.018.009
709.150.003
722.006.054
722.006.004
445.160.001
455.030.020
455.030.024
455.030.004
455.030.005
455.030.003
715.097.200
301.140.003
301.140.004
704.025.013
306.050.020
306.050.021
101.097.010
706.052.002
442.042.011
462.042.011
462.042.011
600.058.001
705.059.006
BA-0005 • 2020-10-19