Product Safety; Emergency Information - Jackle JESS WELDING maxiMIG 250 Betriebsanleitung

2 Safety
Describes a potentially harmful situation. If not avoided, this may result in slight or minor injuries.
NOTICE
Describes the risk of impairing work results or potential material damage to the equipment.

2.5 Product safety

The product has been developed and manufactured in accordance with state-of-the-art technology and the
recognized safety standards and regulations. These operating instructions warn you against unavoidable
residual risks to users, third parties, devices or other material property. Disregarding these warnings may
result in risks to human life and health, environmental damage or material damage.
• The product may only be operated in an unmodified, technically perfect condition, within the limits
• Always observe the limit values specified in the technical data. Overloads lead to destruction.
• Safety features on the device must never be disassembled, bridged or otherwise bypassed.
• During welding work outdoors, use suitable protection against the weather conditions.
• Check the electrical device for any damage and for proper functioning in accordance with its
• Never expose the electrical device to rain and avoid damp or wet environments.
• Protect yourself from electrical accidents by using insulating mats and wearing dry clothing.
• Never use the electrical device in areas subject to a risk of fire or explosion.
• Arc welding may cause damage to the eyes, skin and hearing. When working with the device, always
• Metal vapours, especially from lead, cadmium, copper and beryllium, are all harmful to health! Ensure
• Rinse workpieces that have been degreased with chlorinated solvents using clean water to prevent the
• Adhere to the general fire protection regulations and remove flammable materials from the vicinity of
2.6 Warning and notice signs
The following warning and notice signs can be found on the product:
Symbol

2.7 Emergency information

In the event of an emergency, immediately disconnect the following supplies:
• Electrical power supply
• Compressed-air supply
• Gas supply
Further measures can be found in the operating instructions for the power source or the documentation for
other peripheral devices.
EN - 2
CAUTION
described in these instructions.
designated use.
wear the prescribed protective equipment.
sufficient ventilation or extraction. Always ensure compliance with the legal limit values.
risk of phosgene gas formation. Do not place degreasing baths containing chlorine in the vicinity of the
welding area.
the welding work area prior to starting work. Keep suitable fire extinguishing equipment at the
workplace ready for use.
Meaning
Read and observe the operating instructions!
Disconnect the mains plug before opening!
Warning for hot surface!
maxiMIG 250/300
BA-0005 • 2020-10-19