Jackle JESS WELDING maxiMIG 250 Betriebsanleitung Seite 33

7 Operation
7.1.2 maxiMIG 300
Fig. 6
A
B
H
G
F
E
D
Tab. 4
Pos.
(A)
(B)
(C)
(D)
(E)
(F)
(G)
(H)
EN - 10
Front view of maxiMIG 300
Welding grade switch C
Wire feeder speed controller D
E
maxiMIG 300 control elements
Description
Welding grade switch, 12 grades
For continuous adjustment of the required wire feeder speed between 1.0 and 24 m/min.
Switch for selecting the operating mode: 2-cycle/4-cycle/spots.
 Description of symbols on page EN-11
The spot time can be adjusted between 0.5 seconds and 10 seconds. For normal welding
operation, the knob must be in position "0" (turned to the left stop).
Main switch
• Position "0": switches the machine off.
• Position "1": switches the machine on.
Central connection for welding torch cable assembly.
Temperature fault light. Lights up to indicate thermal overload of the machine. The welding
process can no longer be started using the torch trigger. If the ventilator is running, the
machine will ready for operation after approximately 5 minutes.
maxiMIG 300 nameplate. Contains the technical specification of the machine.
2-cycle/4-cycle selector switch F
Spot-time control dial G Temperature fault light
H maxiMIG 300 nameplate
Main switch
maxiMIG 250/300
Central connection
A
B
C
BA-0005 • 2020-10-19