Initial Commissioning; Systeminfo - Kessel Comfort PLUS Einbau- Und Betriebsanleitung

5

Initial commissioning

Connect the battery
Connect the battery connector(s) (2).
5.1 Connect to the mains voltage
Establish mains voltage (400V control units)
Connect the mains cable to the mains power supply.
Move main switch (1) into ON position.
✓ Initialisation starts automatically.
The device checks the electrical components.
Voltage test of the standby batteries.
|3.10. Language|
Menu item
Establish mains voltage (230V control units)
Insert the safety plug into the designated socket.
Move main switch (1) into ON position.
Initialisation starts automatically.
The device checks the electrical components.
Voltage test of the standby batteries.
|3.10. Language|
Menu item
Switch on
Move main switch (1) into ON position. After a successful system test, the display shows
green LED signals readiness.
If the display does not show initialisation (
the set parameters must be checked or reset to the factory settings (
tings, the initialisation of the control unit starts automatically.
Please note that the counter for the maintenance interval is not changed by the reset to the factory settings.
38 / 148
is displayed.
is displayed.
|3.10. Language|
) the control unit has already been initialised. In this case,
|3.11 Reset|
Installation and operating instructions
2
1
|0 System info|
). After resetting to the factory set-
and the
010-700_04