Parkside PLV 1500 B1 Originalbetriebsanleitung Seite 27

terrain and remain focused on
the potential hazards that you
could miss on account of the
motor noise.
• Always maintain a secure foot-
ing while working, especially
on a sloping terrain. Always
work across slopes - never up
and down! Be particularly care-
ful when changing the travel-
ling direction. Do not scarify or
aerate on overly steep slopes.
This enables you to control the
equipment better in unexpected
situations.
• Avoid an abnormal body posture.
Walk, do not run.
• Always guide the implement at
a walking pace with both hands
on the handle. Be especially
careful when you turn the imple-
ment around or draw it towards
you. Danger of stumbling!
• Start or operate the start lever with
care corresponding to the instruc-
tions in this instruction manual and
keep your feet at a safe distance
from the prongs.
• Do not tilt the implement when
starting, other than it has to be
lifted. In this case tilt the imple-
ment only to the extent that is ab-
solutely necessary and always
lift the implement on the side that
is opposite to the operator.
• Never operate the implement
without the attached collection
bag or impact protector. Dan-
ger of injury!Never place your
hands or feet on or below rotat-
ing parts. Always keep away
from the ejector opening.
• Do not operate the implement in
the vicinity of inflammable liq-
uids or gases as this could give
rise to the danger of a fire or
explosion.
• Always disconnect the plug from
the mains socket before working.
• Hold the prongs if the machine
needs to be tipped over for
transport over areas other than
grass and if the machine is
moved from and to the area to
be treated.
• Keep connection and extension
cables away from the prongs.
• Never transport the machine
while the drive is running.
Work intervals:
• After the implement has been
turned off, the cutting cylinder
will continue to rotate for a few
seconds. Keep hands and feet
well away.
• Do not touch the spring tines be-
fore the implement has been dis-
connected from the mains and
the spring tines have come to a
complete standstill. Risk of injury
owing to a sharp implement!
• Only remove plant parts when the
implement is standing completely
still. Ensure that the grass ejec-
tor opening is clean and free.
• Switch off the power when the
implement is to be transported,
lifted or tilted and when travers-
ing other surfaces than grass.
• Children must never play with
the device.
• Always switch off the implement
and disconnect the power plug.
Make sure that all moving parts
have come to a complete stop:
- Whenever you leave the im-
plement
GB IE
27