Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation under a worktop
3
1
4
Air inlet min. 250 cm2
– Veneers or plastic coverings on the built-
in furniture require heat-resistant adhesive
(100 °C). If the adhesive and surfaces are
not heat-resistant, the covering may warp
and come loose.
– An intermediate shelf is required if a draw-
er is to be installed below the oven.
– The installation recess may not have a rear
panel, at the most it may have an add-on
edge measuring no more than 50 mm.
– The built-in cabinet can be equipped with
either ledges/rails or an intermediate shelf
with ventilation cut-out.
Installation in an upright cabinet
2
4
Air inlet min. 250 cm2
Installation
3
2
5
1
Ventilation grille
– The installation recess must have the fol-
lowing minimum dimensions
– Installation under a worktop
❶
460 mm
➋
560
mm
+8
❸
min. 550 mm
➍
50 mm
– Installation in an upright cabinet
❶
450
mm
+2
➋
560
mm
+8
❸
600 mm
➍
min. 550 mm
❺
min. 45 mm
❻
6 mm
Page EN-27
6
Cabinet legs
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
