Finishing Work - ATIKA ASP 11 N Originalbetriebsanleitung, Sicherheitshinweise, Ersatzteile

Splitting short wood:
1. Upper position of table plate.
2.
Place the log on the splitter's table plate.
Only split the logs in the direction of the wood fibres.
3. Hold the log tight with the clamping claws.
Splitting long wood:
1. Middle position
of table or low
position of base.
2. Remove the
splitting cross.
3. Place the log on
the splitter's
table or base.
Possible malfunction when cleaving logs: The log to be
cleaved is not cleaved right through, jams on the cleaving
blade and is pulled up during the blade's return movement.
In this case, proceed as follows:
1. Switch off the device.
2. Depending on the log still to be cleaved fix the table plate
in the upper or the table in the middle position.
3. Switch on the device and continue the splitting operation.
Never try to split two logs at once.
Never try to remove or replace the log during the
splitting process.
Never try to force the splitting of the log by maintaining
the pressure for several seconds. This can lead to damage to
the machine.
Position the log on the table again and repeat the splitting
phase, or put the log on one side.
Downloaded from www.Manualslib.com
Star grip screw
Splitting cross
manuals search engine
How to release a jammed log?
There is a risk of knotted logs getting stuck during the
splitting process.
1. Switch machine off and remove the spark plug connector.
2. Do not remove jammed logs with your hand
3. Carefully move the stuck log with a crowbar backwards
and forwards to loosen it. Don´t damage the splitting
pillar.
Never hammer on the stuck log.
Never use a saw to cut the stuck log out of the machine.
Do not enlist the aid of a second person - this is a one-
man job.

Finishing work:

Bring the splitting blade to the lower position (run-in
state).
Release one of the control handles.
Switch the machine off and disconnect the power.
Follow the care and maintenance instructions.
C a r e a n d m a i n t e n a
C a r e a n d m a i n t e n a
Before each maintenance and cleaning work
− Stop the engine.
− Remove the spark plug connector.
Do not carry out maintenance work close to open
flames. Risk of fire.
For maintaining and cleaning, removed security devices
must unconditionally be mounted properly and proved again.
Use only original parts. Other parts can result in unexpected
damages and injuries.
Wear protective gloves in order to avoid injury to
the hands.
Be sure to have removed any tools from the machine after
completion of service work.
Maintenance and repair work other than those described in
this chapter is only allowed to be carried out by service staff.
To guarantee a long and reliable usage of the product carry
out the following maintainance works regularly.
Observe the following in order to keep the log splitter in
good working order:
Clean the machine thoroughly after you have
finished using it.
Loose fastening elements.
Worn out or damaged parts.
Leaks from the fuel tank cap or fuel lines.
s.
n c e
n c e
31