VDO Ocean Line Combi Montage- Und Bedienungsanleitung Seite 43

3.4.4 Indicator setting (Change Gauge Config)
In this menu you will find:
- External illumination
- Gauge is a...
- Speed comes from
- Change c-factor
- Change keel settings
- Depth damping
3.4.5 Setting the illumination (External Illumination)
Here select whether the illumination of the Ocean Line Combi and the
connected bus devices is to be internally or externally controlled.
The following options are available:
EXTERNAL The illumination is switched on and off via an input of the 14-pole
connector.
Dimming of the illumination is impossible.
INTERNAL In normal operating mode, the illumination is regulated in 8
stages by pressing and holding down the push-button. Please
observe that the illumination can only be adjusted in the event
of display indications speed, water temperature and on-board
voltage. With display indication depth and trip/distance,
depression of the button has a different function.
3.4.6 Selection main/subsidiary device (Gauge is a...)
Select here whether the indicator is to be used as a main device or as an
ancillary device.
The following options are available:
MASTER The indicator receives measured values from the transmitter
inputs
REPEATER The indicator receives measured values from the CAN bus.
The transmitter inputs are deactivated. The following basic
settings are unavailable in this operating mode:
- Speed comes from
- Change c-factor
- Change keel settings
- Set alarm
42
adjustment of illumination (refer to page 42)
selection main / ancillary device (see page 42)
speed signal source (refer to page 43)
adjustment of the log correction factor
(refer to page 43)
adjustment of the keel depth (refer to page 45)
adjustment of depth indicator damping
(refer to page 46)