Basic Settings - VDO Ocean Line Combi Montage- Und Bedienungsanleitung

3.4 Basic settings

The basic settings required for faultless operation can be selected in
settings. To access the settings, press and hold down the push button
while switching on the power supply of the indicator.
- Display Units
- Speed Units
- Change LCD Contrast
- Change Gauge Config setting of operating functions
- Screens on / off
- Simulator Mode
- Exit Setup
To change a value (e.g. from No to Yes), briefly press the push-button.
To maintain a value, keep the push-button depressed until the set value
flashes once. Then release the push-button immediately. The displayed
setting is thereby assumed.
The displayed setting is automatically assumed after 10 seconds if the
push-button is not pressed.
3.4.1 Selection of display units (Display Units)
The values for water depth (m/feet) and water temperature (°C/°F) can
alternatively be displayed in metric (METRIC) or Imperial (ENGLISH)
units.
Select the units as follows:
Example:
DISPLAY UNITS
METRIC
In the diagrammed example, the unit is changed from METRIC to
ENGLISH.
40
selection of display unit (refer to page 40)
selection of display unit (refer to page 41)
selection of display contrast
(refer to page 41)
(refer to page 42)
selection of display indications
(refer to page 47)
activation of the simulator mode
(refer to page 47)
exit settings (refer to page 47)
Press push-button
DISPLAY UNITS
ENGLISH