Assembling Instructions; Assembling The Curved Handle; Installing The Grass Box; Operation - Parkside PRMA 20-Li A1 Originalbetriebsanleitung

GB IE
Observe the safety in-
formation and notes on
charging and proper
use as shown in the
instruction manual for
your battery and char-
ger from the Parkside
X 20 V Team series. A
detailed description of
the charging process
and further informati-
on can be found in the
separate operating inst-
ructions.

Assembling instructions

• Alwayas wear cut-protection gloves
• Undertake only work with which you
are confi dent.
• In case of uncertainty, contact a spe-
cialist or contact our service directly
Assembling the
Curved Handle
Installing lower bars:
1. Slide the two ends of the lower
handle bar (3) into the receptor
on the mower housing.
2. Fix the lower bar by means of
the tensioning levers (2a).
3. Lock the clamping levers (2a) by
pushing them towards the bar (1).
Clamping levers to be tightened
and contacting the bar such that
they clamp at average force.
Otherwise you may have to
tighten (turn clockwise) or loosen
them (turn anticlockwise).
There are two positions possible.
26
Installing upper handle:
4. Attach the bow-type handle (1)
to the lower bars (3) with the en-
closed wing nuts (2b) and quick
release levers (2a).
Mounting cable holder:
5. Clip the cable holder (
into the bar (3) and thus fi x the
cable ( A
If you release the quick release
levers (2a), you can fold the bow-
type handle (1) downwards to store
the device. Ensure that the power
cable ( A

Installing the grass box

1. Pull the plastic straps over the linkage
tubes.
2. Insert the handle (4a) of the grass
collection box (4) into the provided re-
ceptacle on the upper side of the grass
collection box (4).
Do not operate the appliance
until the collision guard and
grass box are fully installed.
Risk of injury!

Operation

The mower must only be set
when the motor is switched
off and the blades are shut-
down. There is a risk of per-
sonal injury.
Switch of the device, pull the ig-
nition key (12) and wait for the
blades to come to a stop.
A
14)
13).
13) is not caught.