Parkside PRMA 20-Li A1 Originalbetriebsanleitung Seite 24

GB IE
away from the ejection hole at
all times.
• Do not start the motor when
standing in front of the dis-
charge chute.
Caution! Danger! The blade
continues to run after switch-
ing off. There is a risk of in-
jury.
• The equipment is not to be lifted
or transported while the motor
is running. Switch off the equip-
ment if it has to be tilted in
transit, when crossing surfaces
other than grass, and when the
equipment is being transported
to and from the surfaces to be
mowed.
• Always keep the grass ejection
hole clean and clear. Remove
cut material only when the
equipment is stopped.
• Do not leave the equipment un-
attended in the workplace.
• Do not work with equipment
that is damaged, incomplete, or
has been modifi ed without the
authorisation of the manufac-
turer. Do not use the equipment
with damaged safety devices or
screens or with missing safety
equipment such as defl ection
and/or grass collection devices.
• Do not overload the equipment.
Work only within the speci-
fi ed power range and do not
change the regulator settings on
the motor. Do not use low-pow-
ered machines for heavy work.
Do not use your equipment for
purposes other than those for
which it is designed.
24
• Do not use the equipment near
infl ammable liquids or gases.
Non-observance will result in a
risk of fi re or explosion.
• Switch the device off, remove
the safety key and take out the
battery. Make sure that all mo-
vable parts are stationary:
- whenever you leave the
apparatus unattended and
when it is not being used,
- before removing obstructions
or loosening blockages from
the discharge chute,
- before checking or cleaning
the apparatus or performing
any work on it,
- when a foreign object has been
hit by the apparatus. Check
for damage to the apparatus
and carry out the necessary
repairs before switching it on
again and working with it,
- if the apparatus starts to vi-
brate excessively, an immedi-
ate check is required.
- make sure that all nuts, bolts
and screws are properly tight-
ened.
- inspect the apparatus for any
damage.
- have any necessary repairs
carried out to damaged parts.
• Do not place feet or hands near
or under rotating parts. Do not
stand in front of the grass ejec-
tion hole during sickle mowing.
• Always pull the circuit breaker/
ignition key if:
- you leave the apparatus
unattended, before clearing
blockages,
- if you check or clean the ap-
paratus or work on it,