Trouble Shooting - Parkside PRMA 20-Li A1 Originalbetriebsanleitung

GB IE

Trouble Shooting

Problem
Equipment does not start
Motor stops
Result unsatisfactory or
motor labours
Blade fails to turn
Strange noises, rattling
or vibrations
30
Possible Cause
Battery is empty or not
inserted
Defective start lever (
or release button (
Worn carbon brushes
Defective motor
Grass too long
Blockage by foreign object
Cut height too low
Blade ( 18) blunt
Blade area blocked
Blade ( 18) assembled
incorrectly
Blade blocked by grass
Blade screw ( 19) loose
Blade screw ( 19) loose
Blade ( 18) damaged
Fault Fixing
Check charge level,have re-
pairs carried out by a qualifi ed
electrician, if necessary
16)
A
15)
A
Repair by customer services
Set a greater cut heigh. Lift the
front wheels slightly by press-
ing down on the handle bar.
Remove the foreign object
Set a higher cut height
Have the blade sharpened or
replace it
Clean the equipment
Install the blade correctly
Remove the grass
Tighten the blade screw
Tighten the blade screw
Replace the blade