Connecting The App To The Device; Cleaning - Steinbach APPcontrol Originalbetriebsanleitung

2. Slowly lift the device out of the water by the handle
surface for 10 to 15 seconds so that most of the water can flow back into the pool.
3. Set down the device next to the pool.
The device is lifted out of the pool.
Clean the device after each use to ensure continued fault-free operation.

Connecting the app to the device

1. Activate Bluetooth.
If you use an android device, you might have to activate GPS as well.
2. Start the "Steinbach APPcontrol" app.
3. Start the device detection.
4. Tip on the displayed device to connect it to the app.
Once the connection has been successfully established, the connection status
indicates "connected".
The app is connected to the device.

Cleaning

Improper cleaning might damage the device.
- Clean the surface of the device with plain tap water after each
use.
- Do not use any aggressive cleaning agents.
- Do not use any sharp or metal objects such as knives, hard
scrapers or similar.
- Do not use any cleaning brushes.
- Do not use a high-pressure cleaner.
Cleaning the device
1. Remove and clean the filter units.
2. Rinse the device and the floating cable after each use with plain tap water inside and
out.
The device is clean.
8
NOTICE!
and hold it above the water
49