First Start Up; Unpacking; Assembly; Machine Positioning - Beissbarth MS 80 Originalbetriebsanleitung

4.

First start up

4.1

Unpacking

1. Remove the packaging paying attention to nails
detaching.
i
After unpacking check the integrity of MS 80 and
check that no components are visibly damaged. In
case of doubt do not proceed to start-up and con-
tact a qualified technician and/or your vendor.
2. Take out of the transport crate the standard accesso-
ries and the packaging materials.
i
Dispose correctly of packaging material, hand it over
to the designated collection points.
4.2

Assembly

4.2.1

Machine positioning

1. Attach suitable straps of equal length and adequate
loadbearing capacity as shown.
Warning - tilting danger!
The barycentre of the MS 80 does not lie in
its centre.
€
It is necessary to lift the machine slowly.
Beissbarth GmbH
First start up | MS 80 | 33
2. Lift the MS 80 with a lift crane and install it in the
designed area respecting the minimum distances
shown in the picture.
i
For safe and ergonomic use of the MS 80 it is recom-
mended to leave a minimum of 750 mm space from
the nearest wall and of 900 mm from the ceiling.
Warning - tilting danger!
During tire inflation considerable forces are
exerted.
€
The MS 80 has to be fixed in at least 3
points on the floor (screw holes see chap.
4.2).
en
|
1 695 301 988 2011-04-04