Tire Mounting; Mounting - Beissbarth MS 80 Originalbetriebsanleitung

5.3

Tire mounting

Danger of car accidents caused by damaged
rims or tires!
In case of tire or rim damage during moun-
ting dangerous or even lethal situations may
occur during driving.
€
The operator has to be specifically trained.
€
Do not exert excessive forces on the tire or
the rim, adjust the slow rotation speed.
€
Use a sufficient quantity of mounting
paste.
€
In case of anomalies, e.g. suspicious noi-
ses, stop mounting immediately.
€
For mounting of critical rim/tire combina-
tions, read the Wdk publications available
in German and English!(www.wdk.de:
mounting/demounting instructions – crite-
ria catalogue).
Warning - tire damage risk!
Cracks in case of operation on cold tire. Tire
explosion in case of high speed.
€
Inner temperature of the tire must be at
least 15 °C.
€
Read the Wdk publications available in Ger-
man and English! (www.wdk.de: mounting/
demounting instructions – tire overheating)
€
Before mounting put the tire in a temperate
room.
5.3.1

Mounting

Warning – hand injury danger!
During locking plate rotation there is a risk of
crush injuries.
€
Do not insert the fingers between the tire
and the rim.
Mounting of tubeless and supersingle tires
1. Lubricate with mounting paste both tire beads, the
shoulder and the drop centre of the rim.
2. Operating the working arm movement control, re-
lease the working arm.
3. To mount tires which present no particular difficulty
bring the cover (lean it over) the platform.
4. Use the pedal to make the locking flange rotate and
in the mean time insert and lower the rim, pressing
on the on the cover bead in order to allow the upper
part of the rim to get into the tire.
Beissbarth GmbH
Operating instructions | MS 80 | 41
5. While operating the tool movement control, rotate
the tool so that the disk faces the side of the tire
that has to be mounted and, by means of the same
control, lock the operating arm.
6. Press with the bead breaking disk the side of the tire
towards the rim drop centre and operate the pedal
to rotate without any interruptions the locking flange
until complete insertion of the tire on the rim.
7. If this is not possible, block the heeled tyre part
using the pliers supplied (1) and then by activating
the working arm shifting control, use the bead brea-
king disk to press the side of the tyre towards the
rim centre and, use the pedal to turn the tightening
flange without interruption until the tyre is complete-
ly inserted onto the rim.
i
To mount particularly hard tubeless and supersingle
tires follow the instructions given for agricultural
wheels.
en
1
|
1 695 301 988 2011-04-04