Beissbarth MT 857 L Betriebsanleitung Seite 74

en 74 | MT 857 L | Balancing a wheel
i
In the standard program, the software will
automatically suggest an estimate of the rim width.
By using the corresponding function, the data can
be entered or changed manually.
For efficient measurements, it is recommended to
use the angle gauge and the sonar probe. Refer to
the associated manuals.
2. Position the electronic rim distance gauge at the 2nd
measurement point (without previously moving the
electronic rim distance gauge to its rest position),
and keep it in that position for 1 second.
Fig. 33: 2nd measurement point and 2nd balancing plane for
ALU3
2nd measurement point and 1st balancing plane for
ALU2
 Storage of the position is confirmed by an acous-
tic signal and the position data are displayed.
Fig. 34: Showing the 2nd measurement point for ALU3
|
1 695 656 930 2019-08-05
Fig. 35: Showing the 2nd measurement point for ALU2 on the
display
ALU3
i
If the electronic rim distance gauge is put back in
the resting position, the ALU3 balancing program
will be selected automatically. For ALU2, proceed
ALU2
with the following steps without moving the rim
distance gauge to its rest position.
651127-67_BM
3. Position the electronic rim distance gauge at
the 3nd measurement point (without previously
moving the electronic rim distance gauge to its rest
position), and keep it in that position for 1 second.
Fig. 36: 3rd measuring point and 2nd balancing plane for ALU2
 Storage of the position is confirmed by an acous-
tic signal and the position data are displayed.
ALU2
Beissbarth GmbH