Program Structure; Wheel Balancing - Beissbarth MT 857 L Betriebsanleitung

en 68 | MT 857 L | Program structure
8.

Program structure

8.1

Wheel balancing

To proceed, confirm by pressing < I >.
Selection of user 1, 2 or 3. The last settings and rim data
selected are assigned to the current user and stored.
Selection of type of vehicle (passenger car or
motorcycle); the type of vehicle selected is displayed in
the status bar.
Call-up of the "Enter rim data" menu.
Selection of balancing program; 11 passenger car
programs, 5 motorcycle programs; the program selected
is displayed in the status bar.
Starts measurement.
Ends measurement.
Display of the exact, non-rounded unbalance measured
value.
Selection of the number of spokes for the SPLIT
program. After the imbalance measurement, the balance
weights can be distributed behind the spokes.
Call-up of the "Unbalance minimization" program
(refer to Section "Unbalance minimization").
Press < I > to return to the previous page.
|
1 695 656 930 2019-08-05
8.2 Settings and service
Call-up of service menu (customer service only)
Call-up of calibration menu
Press < I > to return to the previous page.
Settings
User-defined settings
i
The following symbols are used in the selection
menus:
Automatic transfer (e.g. time).
Manual transfer (e.g. via pedal).
Function deactivated.
Beissbarth GmbH