Floor Mounting - Beissbarth MT 857 L Betriebsanleitung

5. Set up the machine in the intended area, paying
attention to the specified safe distances.
i For safe and ergonomic operation of the wheel
balancing machine, it is advisable to set it up at a
distance of 500 mm from the nearest wall.
500 mm
Fig. 8: Safe distances
4.3

Floor mounting

Warning – danger of tipping!
Considerable forces are involved in the wheel
balancing process.
¶
Before using the machine, it is essential
to fasten it to the ground according to the
manufacturer's specifications.
1. Place the MT 857 L on the ground at the intended
final location. Use the bore holes in the base of the
machine for orientation.
Fig. 9: Overview of mounting holes
2. Position a power drill with a 14-mm bit, and drill
holes 65 mm deep.
!
We recommend cleaning the hole carefully before
inserting the dowel.
Beissbarth GmbH
Commissioning | MT 857 L | 61
3. The wheel balancing machine must be secured to
the ground at a minimum of 3 places with screws
and dowels.
1
2
3
Fig. 10: Securing the MT 857 L
4. Insert the dowels provided, insert the washers
in between, and fully tighten them with a torque
wrench at a tightening torque of 25 Nm.
4.4 Fitting wheel guard
i
After the machine has been moved, the screws and
the nut must be removed from the holder for the
wheel guard.
¶
Attach the wheel guard to the shaft and secure using
the two bolts and nuts included in the scope of delivery.
1
M10x70
2
M10
2
Fig. 11: Fastening the wheel guard
en
1
1
2
M8x70
2
8,5x24x4
3
3
Ø8
1
|
1 695 656 930 2019-08-05