Philips PerfectDraft HD3620 Bedienungsanleitung Seite 21

Problem
appliance general
It is not possible to close
the doors.
There is frost on the keg
or on the appliance.
Beer leaks out of the
appliance.
The appliance makes a
sound.
The pump goes on
frequently when I am not
pouring beer.
tap unit
It is difficult to place the
tap unit onto the keg.
It is difficult to press the
release buttons to remove
the tap unit.
Solution
Make sure you push down the blue locking levers until they are in
horizontal position before you close the doors.
Make sure the tube is placed correctly in the tap unit and the tap handle is
in upright position. See chapter 'Preparing for use', section 'Placing the tube
into the tap unit'.
Make sure the tap unit is placed correctly on the keg.
Unplug the appliance and let the keg or appliance defrost. Dry
the appliance or keg with a cloth.
Make sure that the doors are properly closed. For instructions on how to
close the doors, see the chapter 'Preparing for use', section 'Placing the keg
into the appliance'. It is normal for some frost to be present on the back of
the keg.
Make sure that the tap unit and the tube are placed correctly (see chapter
'Preparing for use', sections 'Placing the tap unit onto the keg' and 'Placing
the tube into the tap unit').
Remove the tap unit and tube and reinstall them. If the problem continues
to occur, contact the PerfectDraft call centre in your country to obtain a
new tube.
Because the appliance chills constantly, the fan works continuously.
The pump may go on while you pour beer to maintain the right pressure.
When you are not pouring beer, the pump also goes on every now and
then to keep the appliance at the right pressure.
If the appliance makes a hissing sound, the tap unit may not be properly
connected to the keg. Make sure you rinse the tap unit thoroughly. It
is essential that all rubber parts of the tap unit are moist before you
assemble the tap unit onto the keg.
Reinstall the tap unit and the keg by following the instructions in sections
'Placing the tap unit onto the keg' and 'Placing the keg into the appliance'
in chapter 'Preparing for use'. If this does not help, try another keg
together with a new tube. If the problem continues to occur, contact the
PerfectDraft call centre in your country.
Make sure no old beer is left in the tap unit. Clean the entire tap unit with
hot water and, if necessary, some washing-up liquid.
First remove the keg from of the appliance. Then press the release buttons
to remove the tap unit from the keg.
Beer residues may cause the tap unit to stick to the keg. Clean the tap unit
with hot water and, if necessary, some washing-up liquid to dissolve beer
residues. Then remove the tap unit from the keg.
EnglisH
21