Guarantee & Service; Guarantee Restrictions - Philips PerfectDraft HD3620 Bedienungsanleitung

EnglisH
20
6 Undo the screws with a screwdriver.
7 Remove the aluminium plate.
After you have removed the aluminium plate, you see a white plate
,
of approx. 4 x 4cm. This is the actual cooling element.
8 Place the shaft of a screwdriver against one side of the cooling
element and push the cooling element off the back of the aluminium
plate.
9 Cut the wires attached to the cooling element.
Do not connect the appliance to the mains again after you have removed
the cooling element.
Never reassemble the cooling element once you have removed it.
10 Hand in the cooling element at an official collection point for
chemical waste.
guarantee & service
If you need information or if you have a problem, contact us online at
www.philips.com or call the PerfectDraft call centre. Their phone number
is 078-250159 (Belgium), 01801-324000 (Germany) or 0900-2224222
(Netherlands).
When you take the appliance to your dealer or a Philips service centre for
determination of the cause of the problem, also bring the tube and the keg.

guarantee restrictions

Your guarantee becomes invalid if:
- you do not use the appliance according to the instructions in this user
manual.
- you use damaged kegs in this appliance.
- you do not install the kegs according to the instructions in this user
manual.
- you use kegs from other suppliers than the ones mentioned in this user
manual.
The kegs and tubes are not covered by this guarantee.
,
troubleshooting
If you are unable to solve the problem with the information below,
contact us online at www.philips.com or call the PerfectDraft call centre
at 078-250159 (Belgium), 01801-324000 (Germany) or 0900-2224222
(Netherlands).