EnglisH
12
1
Slide the release button to the right to open the doors.
2
Lift the two blue locking levers completely.
3
Tilt the keg with the assembled tap unit slightly forward and put it
into the appliance.
-
First put the keg on the cooling plate of the appliance.
-
Then put the keg upright by sliding the tap unit between the blue
locking levers.
4
Push down the blue locking levers until they are in horizontal
position.
If you are unable to put the locking levers in horizontal position, you have
not put the keg into the appliance in the right position. Take out the keg
and follow steps 1 to 3 again.
After you have installed the keg (even the first time), the pump runs
,
for a few seconds.
5
Close the doors.
Note: If the pump goes on frequently when you are not pouring beer, reinstall
the keg or repeat the instructions in section 'Placing the tap unit onto the keg'
in this chapter.