Preparing For Use - Philips PerfectDraft HD3620 Bedienungsanleitung

EnglisH
10
2
1

Preparing for use

Placing the tap unit onto the keg
Always clean the tap unit with water and, if necessary, with some
washing-up liquid before you place it on the keg and insert the tube.
1 Remove the protection cap and the tube from the keg.
2 If present, remove the tube connector and the tube from the tap
unit. Hold the tap unit under a running tap and rinse the tube-
connection hole (1) and the connection to the body of the appliance
(2). If necessary, use some washing-up liquid.
3 Then turn the tap unit upside down and rinse the keg connection in
the bottom of the tap unit.
It is essential that all rubber parts of the tap unit are moist before you
assemble the tap unit onto the keg.
4 Check if the tube release button works properly. When you press
the blue tube release button, the two clamps in the opening have to
move.
Note: If the clamps fail to move when you press the blue tube release button,
rinse the tube-connection hole under a running tap again.
5 Put the tap unit onto the connection top of the keg by pushing it
down firmly ('click').
When you assemble the tap unit properly, you hear two clicks in quick
succession.
Tip: If you can move the arm of the connection top freely up and down, the tap
unit is placed properly on the keg.