Networks; Ethercat - Lenze i950 Montage- Und Einschaltanleitung

Networks

EtherCAT

LED "RUN" (green)
Blinking pattern
off
Blinking 1:1
Flashing
On
LED "ERR" (red)
Blinking pattern
Off
Single flash
Double flash
Blinking 1:1
LED "L/A"
Blinking pattern
off
on
blinking
Typical topologies
M Master
SD Slave Device
Bus-related information
Name
Communication medium
Use
Status display
Connection designation
Status
Off
Initialization (Init)
Pre-Operational (Pre-Op)
Safe-Operational (Safe-Op) Process input data (inputs) are valid
Operational (Op)
Status/meaning
No supply voltage
No error
Local error
Watchdog timeout
Configuration error
State
Not connected
Connected
Traffic
M
IN OUT
SD1
EtherCAT
Ethernet 100 Mbps, full duplex
Connection as EtherCAT slave
2 LEDs (RUN, ERR)
IN: X246
OUT: X247
Meaning
Supply voltage not available
Network not active
No data transfer
Access to parameters and objects is possible
No process data transfer
Process data transfer with valid inputs and outputs in action
Line
R
IN OUT IN
SDn
SD2
Electrical installation
Meaning
Network not available
Network available
No data transfer
Data transfer
Networks
EtherCAT
161