Lamp Replacement; Cleaning And Maintenance - Beko HNT61110X Handbuch

3 Installation and Use of the Appliance
• Lamp control switch is on the left side of the
extractor hood when the slider is pulled. (A).
• Motor control switch is on the right side of the
extractor hood when the slider is pulled. (B,C).
• To run the appliance in the first speed level, turn
the speed switch to position (Pic 11/B).
• To run the appliance in the second speed level,
turn the speed switch to position (Pic 11/B).
• To run the appliance in the second speed level,
turn the speed switch to position (Pic 11/C).
• To turn off the appliance, switch the on/off
button on the control panel to
• To turn on the lamp of the appliance, set the lamp
turn on/off switch to
4

Cleaning and Maintenance

CAUTION
Risk of damage due to the corro-
sion damage. Always operate the
appliance while cooking in order
to prevent condensate formation.
Condensate may cause corrosion
damage. Replace immediately the
faulty lamps in order to prevent
A
other lamps from being overload-
ed. The risk of damage occurs due
to the humidity intrusion to the
electronics. Never clean the con-
trollers with a wet cloth. Surface
may be damaged due to improper
cleaning. Clean the stainless steel
surfaces only in the direction of
brushing. Do not use stainless
steel cleaner for controllers.
Kitchen Hood / User Manual
(Pic. 11/ C).
(Pic. 11/A).

3.5 Lamp Replacement

3.5.1 Candle Bulb Replacement
WARNING
A
Cut the power supply of the hood.
Lamps may burn your hands while
hot, so wait for them to cool down.
Picture 12: Candle Bulb Replacement
• Remove the aluminum cartridge filter. Remove
the faulty lamp and replace it with the one
having the same value. Pic. 12
The surface may be damaged due
to abrasive or rubbing cleaning
agents. Never use abrasive or rub-
A
bing cleaning agents. There is the
risk of damage due to backflow of
condensate. Install the air outlet
duct with a slope of 1°, slightly
downwards the appliance.
CAUTION
A
You can use this appliance in
waste air mode and in air circula-
tion mode.
13 / EN