Replacement Of Lamp - Beko HCP61310I Bedienungsanleitung

3 Operation of the Appliance

3.4 Replacement of Lamp

Make the electrical connections of the ap-
pliance. Your appliance is equipped with a 3
W spot LED lamp. For replacing the lamps,
push downwards on the holder from its be-
hind, turn it counter-clockwise, and take it out
downwards. Apply the above operation in re-
verse to install new lamps (Figure 3).
(Figure 3)
Bulb
Bulb Power (W)
Holder / Socket
Bulb Voltage (V)
Size (mm)
ILCOS Code
Cooker Hood / User Manual
3
E14
220 - 240
100 x 35
DRBB/F-3-220-
240-E14-35/100
3.5 Operation with Flue
Connection
Vapour is extracted through
•
the flue duct, which is fastened
to the connection head on the
hood.
The diameter of the flue duct must be the
•
same as the connection ring. In horizontal
settings, the pipe has to have a slight up-
ward slope (around 10º) so that the air can
exit the room easily.
3.6 Operation without
Flue Connection
Air is filtered through the
•
carbon filter and recirculated
in the room. Carbon filter is
used when it is impossible to use a flue in
the house.
In flueless use, remove the flaps inside the
•
flue adapter.
Remove the aluminium grease filter. To in-
•
stall the carbon filter, fit the filter to the tabs
by centring it on the plastic piece on both
sides of the fan body. tighten it by turning
right or left.
Replace aluminium grease filter.
•
9 / EN