Operating The Hood; Lamp Replacement - Beko CTB 6407 W Bedienungsanleitung

Using the appliance
3

3.3 Operating the Hood

• Hood is equipped with a motor having
various speed settings.
• For a better performance, we advise
you to use low speeds in normal condi-
tions, and high speeds when smell and
vapors are intensified.
• You can start the hood by pressing the
desired speed level key.(V1,V2,V3)
• You can illuminate the cooking area by
pressing the light key (L)

3.4 Lamp replacement

• Before replacing the light
bulbs, disconnect the power
supply of the hood.
A
• Do not touch the light bulbs
when they are hot.
• Be careful not to touch the
replaced light bulb directly
with hands.
C
You may procure lamps from
Authorised Service Agents.
Lamp
Bulb power
Cooker Hood / User Manual
4 W
Holder/Socket
Bulb voltage
ILCOS Code
Size
Luminous flux
Correlated colour
temperature
This product contains a light source of
energy efficiency class "F".
3.5 Operation with flue
connection
Vapour is extracted thro-
•
ugh the flue duct, which is
fastened to the connec-
tion head on the hood.
• The diameter of the flue duct must be
the same as the connection ring. In ho-
rizontal settings, the pipe has to have
a slight upward slope (around 10º) so
that the air can exit the room easily.
3.6 Operation without flue
connection
Air is filtered through the
•
carbon filter and recircu-
lated in the room. Carbon
filter is used when it is im-
possible to use a flue in
the house.
• In flueless use, remove the flaps inside
the flue adapter.
• Remove the oil filter. To install the car-
bon filter, fit the filter to the tabs by
centring it on the plastic piece on both
sides of the fan body. Tighten it by tur-
ning right or left.
Replace aluminium oil filter.
•
E14
220 - 240 V
DRBB/F-4-220-
240-E14-35/100
35x100 mm
400 lm
3000 K
11 / EN