SATA AE5606S Bedienungsanleitung Seite 50

2.3 Use of rear wheel wedge
During the king pin measurement, use the rubber block to block the rear wheels, remove the turntable safety pin and then the rubber mat,
in order to prevent the vehicle from moving backward or forward, affecting the measured value. (For reference only)
2.4 Selection of fixture
2.4.1 Introduction of special fixture for four-wheel aligner
The fixture is a special four-jaw fixture designed for four-wheel alignment test. It features aesthetic appearance and flexible use, and can
be used for the four-wheel alignment of ordinary models, as well as the ultra-low chassis models.
Taper pin
50
AE5606S
Hand wheel
Side frame
Polished rod
Middle frame
Screw
Hexagon socket head cap nut
(Fig. 1)
Big nut
Rim
(Fig. 2)
EN DE RU KO PT
The edge of the rim is aligned with
the end face of the clamping jaw
JA ES