Resetting To Factory Settings; Display Message Overview - Conel CLEAR Serie Montage- Und Betriebsanleitung

80
6.13

RESETTING TO FACTORY SETTINGS

All user-defined settings (e.g. residual hardness and residual hardness correction) can be reset to the fac-
tory settings as follows:
Press . The display will show the following:

Press . The display will show the following:
Press <OK> once and then
Press <OK>. The display will show the following:
 
Press or to change between <yes> and <no>.
When <yes> is selected, the following default values are restored by pressing <OK>:
/ Residual hardness 8 °dH
/ Residual hardness correction = 0
/ Backlight 80 %
/ Contrast 80 %
6.14

DISPLAY MESSAGE OVERVIEW

Display
Maintenance/
Service req.
Salt level
verify!
Salt level count
was reset
Main menu
· Regeneration
Main menu
· Settings

five times. The display will show the following:
Setting
· Factory setting
Factory setting
<no>
Description
Message shown after an annual
maintenance period.
Message shown after 100 regener-
ations.
Shown after manual reset of salt
quantity regeneration counter.
Further information
see chapter 9.4 "MESSAGE "MAINTE-
NANCE/SERVICE""
see chapter 6.6.1 "MESSAGE "VERIFY SALT
LEVEL""
see chapter 6.6.1 "MESSAGE "VERIFY SALT
LEVEL""