Operating - Conel CLEAR Serie Montage- Und Betriebsanleitung

70
After successful completion, the display will show the following:
Regulation of residual hardness is pre-configured to a value of 8 °dH.
Please refer to chapter 6.3.1 "SETTING THE RESIDUAL HARDNESS" for more information about setting
another residual hardness.
2. Manually starting the regeneration of the water softener:
The water softener has to be in operating mode. The display shows the operating mode (see fig. 11).
Press . The display will show the following:
Press <OK>. The display will show the following:
 
Press or to change between <yes> and <no>.
When <yes> is selected, the regeneration is started by pressing <OK>.
Subsequently, the display shows "Regeneration".
Regeneration will be completed after approx. 20 minutes. Afterwards, the display again indicates the op-
erating mode. During system operation, regulation of residual hardness to the preset value is automatical-
ly done. To achieve this, approx. 10 litres of water must flow through the water softener.
6.3.1
SETTING THE RESIDUAL HARDNESS
The residual hardness default of the water softener is set to 8 °dH. Another residual hardness is set as fol-
lows:
Press . The display will show the following:

Press . The display will show the following:

Operating

Res.hard. 8 °dH
Fig. 11: Operating mode display
Main menu
· Regeneration
Regeneration
start <no>
Main menu
· Regeneration
Main menu
· Settings