Connecting The Water Softener With The Salt Container - Conel CLEAR Serie Montage- Und Betriebsanleitung

5.10
CONNECTING THE WATER SOFTENER WITH THE
SALT CONTAINER
5
4
1
2
3a/3b Electrode cable connector
The salt container is assembled as follows:
/ Push the filling hose (1) through the opening in the salt container and slide it over the connecting piece.
/ Push the suction hose (2) through the union nut and gasket as far as it will go and manually tighten it.
/ Push the connector (3a) of the electrode cable into the cable socket (3b) as far as it will go.
When doing so, pay attention that both white marks correspond (correct polari-
ty)!
During assembly the connector and the cable socket may not come into contact
with water!
/ Slide the overflow hose (4) over the connecting piece.
Place the salt container below the water softener or next to it on the floor.
Filling hose (ø 6 mm)
Suction hose (ø 4 mm)
Fig. 7: Salt container assembly
1
2
3a
4
5
3b 4
Overflow hose
Wastewater hose
65