Machine In Use With Direct Water Connection; Pid-Display Funcitons; Programming The Temperature Of Both Boilers - ECM SYNCHRONIKA Bedienungsanleitung

6.1.2 Machine in use with direct water connection

. Please make sure that there is always water pressure in the water connection line (indicated on the
pump pressure gauge).
. Now turn the machine on (the metal switch in the upper position and the left switch behind the drip tray
in position 'I').
. Continue as described in chapter 6.1.1
It is recommended to leave the portafilter in the brew group, keeping it warm for optimum
temperature for coffee dispension.
If you would like to plumb your machine, installation through a qualified service technician
is required.

6.2. PID-display funcitons

6.2.1 Programming the temperature of both boilers

During normal operations, the temperatures of the coffee boiler (t1, period in the 1st position) and the steam
boiler (t2, period in the 2st position) are indicated alternately.
The controls are factory pre-set so that both boilers are heated consecutively, whereby the coffee boiler (t1)
has priority. This means that the steam boiler (t2) is activated only after the programmed temperature of the
coffee boiler has been reached.
Please take the following steps to program the temperature of both boilers:
1. Switch the machine on in order to activate both boilers (switch in
position "2"). The temperature of either boiler is of no importance
in programming. Both heaters are inactive during programming.
+ –
2. Press and at the same time until 't1' (coffee boiler) appears
on the display,
+
3. Press in order to progress to the submenu of 't1' and to change
the temperature value. The nominal temperature value is displayed.
4. Quickly press
the nominal temperature value.
5. Please wait a short while after having set the nominal temperature
value;
't1' will be displayed.
–
6. Press in order to display 't2' (steam boiler).
If you would like to change just 't2' and leave 't1' unchanged, press
–
after step 2 in order to progress directly to 't2' and skip 't1'.
Continue with step 7.
Translation of the German original user manual
–
to decrease
+
to increase
ENGLISH
30