ECM SYNCHRONIKA Bedienungsanleitung Seite 39

Problem
The machine is switched on, but
the machine does not work.
The machine is switched on, but
the machine does not work.
The machine does not stop
working and takes in air.
Portafilter/ brew group is
dripping.
Portafilter/ brew group is
dripping.
"CLn" is shown on the display.
There is a dot on the display.
If the machine will not to be used for a long period of time, it is recommended to
.. clean the brew group (see instructions in chapter 7.2). Afterwards, please do not clamp the portafilter back
into the group.
..to empty the boilers. Turn the switch of the operational machine to position off. Open the hot water valve
and the boiler water is now discharged by the remaining pressure through the hot water release. Close the
hot water valve after the water has been released. The coffee boiler is emptied out via the brew group.
Activate the brew group lever and release the water into the drip tray. Please make sure some water remains
in the coffee boiler. Start-up of the machine is the same as initial startup (item 5.).
How to forth
If possible, use cold, fresh milk with a fat content of approx. 1.5 % or 3 %. Even homogenized milk is
•
suitable - if you prefer.
Use a pitcher (made of metal) with a minimum volume of 0.5 litres. The diameter of the pitcher should
•
not be too wide. A narrow and high container is perfect.
Open the steam valve for approx. 5 seconds to release the condensation water and to create dry steam.
•
Fill 1/3 of the frothing container with milk and place it under the steam nozzle. The nozzle should be
•
immersed in the middle of the frothing container, just below the surface.
Slowly open the steam handle or the steam valve. Steam pervades the milk.
•
Keep the pitcher still.
•
After a few seconds you will notice a light suction in the milk jug. Proper frothing begins. Move the milk
•
jug downwards while the milk level increases. The steam nozzle must be kept under the surface of the
frothed milk.
Translation of the German original user manual
Possible Cause
Water has been refilled; PID-
display is off
PID-display is turned off: There is
not enough water in the fresh
water tank
The water tank is not fixed
properly.
Machine in use with water tank,
but switch in position "1" (=
position direct water connection).
Portafilter is not fixed properly.
Group gasket is broken.
The cleaning mode is
programmed
The display is switched off.
Troubleshooting
Switch the machine off and on.
Make sure that the floater in the
water tank is in the correct
position. The side of the floater
with the magnet point must face
towards the inside of the
machine. The floater itself must
be inserted with the magnet point
on the upper part of the floater
side.
Refill water.
Fix the water tank properly.
Place switch into position "0" for
direct water connection.
The switch is located behind the
drip tray.
Fix the portafilter properly
Change group gasket and shower
screen.
Clean the brew group. After
having operated the brew lever 10
times, the "CLn" will disappear.
+
Press to turn it on.
ENGLISH
38