Programming The Temperature Mode "O; Programming The Cln Group Cleaning Mode - ECM SYNCHRONIKA Bedienungsanleitung

+
7. Press in order to progress to the submenu of 't2' and to change
the temperature value. The nominal temperature value is displayed.
8. Quickly press
the nominal temperature value.
9. Please wait a short while after having set the nominal temperature
value;
't1' will be displayed.
–
10. Press 2 x in order to leave the programming mode. The newly
programmed nominal temperatures are now saved. Both heaters
are now activated successively.

6.2.2 Programming the Temperature Mode "o"

You can also set whether the temperature values of t1 and t2 should be displayed in °C or °F.
To adjust this setting, proceed as follows:
+ –
1. Press and at the same time and "t1" will appear on the display.
–
2. Press the button
+
Press to enter the menu.
3. Now you can choose between C for Celsius and F for Fahrenheit by
–
pressing . This will also set t2.
4. Wait a short time and you will exit the menu automatically.

6.2.3 Programming the CLn group cleaning mode

With the Synchronika you have the option to program a reminder for next the group cleaning at the PID
display. The machine is set to 0 at the time of delivery, so no reminder is programmed yet.
Please take the following steps to program the cleaning reminder:
+
–
Press and at the same time and "t1" will appear on the display.
–
Press the button until you reach "CLn". Press
menu.
Now you can carry out the programming in steps of 10 (0-200) by
+ –
pressing and . In order to leave the programming mode, wait until
"CLn" appears and then press the
least 10 brewing cycles until the temperature indication re-appears on
the display (see 7.2 Brew group cleaning).
Translation of the German original user manual
–
to decrease
+
to increase
twice. After t1, and t2, "o" appears on the display.
–
button.
+
to enter the CLn
ENGLISH
31