Cleaning The Accessories; Cleaning, Checking And Replacing Seals - Silvercrest MONSIEUR CUISINE ÉDITION PLUS Bedienungsanleitung

15.3 Cleaning the accessories

1. Rinse the blender jug 5 with warm wa-
ter and dump the water.
2. Remove the blade assembly 29 (see
"Using and removing the blade assem-
bly" on page 19) and take the seal 28
off (see "Cleaning, checking and re-
placing seals" on page 29).
3. Clean all accessories by hand in a sink
with dishwater or in the dishwasher.
4. When cleaning by hand, rinse all parts
with clean water.
5. Allow the parts to dry completely before
using them again.
6. Before using the device again, reinsert
the blade assembly 29.
15.4 Cleaning, checking and
replacing seals
Remove seals 28, 33 and 4 for cleaning
and check them for damage. Pay attention
to changes (e.g. porous material or tears).
- The removed seals 28, 33 and 4 can
be cleaned in the dishwasher.
- Damaged seals 28, 33 and 4 must be
replaced with new ones. You can reor-
der new seals (see "How to order acces-
sories" on page 36).
CAUTION:
Prior to the next use, damaged
seals 28, 33 and 4 must be inserted
again or replaced with new ones. An
operation without seals 28, 33 and 4
in place is not permitted.
Blade assembly
1. Remove the blade assembly 29 from
the blender jug 5 (see "Using and re-
moving the blade assembly" on
page 19).
2. Pull seal 28 off the blade assembly 29.
3. Insert the cleaned seal or a new one.
4. Before using the device again, reinsert
the blade assembly 29.
Deep steamer basket
1. Pull seal 4 off the underside of the deep
steamer basket 3.
2. Insert the cleaned seal 4 or a new one
in the deep steamer basket 3. Ensure
that the seal is in continuous contact
with the surface without any waves.
Lid of the blender jug
1. Pull seal 33 off the underside of the lid
of the blender jug 34.
2. Insert the cleaned seal 33 or a new one
in the lid for the blender jug 34.
29
3
34
GB
29