Legal Information - Ottobock 21Y12 Gebrauchsanweisung

Pull on a 99B81 PVA Bag and laminate.
Before the lamination resin hardens, apply polyethylene adhesive tape to
the small screw ring above the groove in order to squeeze out any exces-
sive lamination resin (fig.13).
After the lamination resin has hardened, remove the socket from the plaster
positive and remove the lamination dummy.
Screw in the upper valve piece (fig.14).
If the valve has become dirty, remove the 21Y145 Upper valve piece using
a pin wrench. Clean the individual components and reassemble.
4 Cleaning
The valve should be cleaned regularly with clear, warm water.

5 Legal information

All legal conditions are subject to the respective national laws of the country
of use and may vary accordingly.
5.1 Liability
The manufacturer will only assume liability if the product is used in accor-
dance with the descriptions and instructions provided in this document.
The manufacturer will not assume liability for damage caused by disregard
of this document, particularly due to improper use or unauthorised modi-
fication of the product.
5.2 CE conformity
This product meets the requirements of the European Directive 93 / 42 / EEC
for medical devices. This product has been classified as a class I device
according to the classification criteria outlined in Annex IX of the directive.
The declaration of conformity was therefore created by the manufacturer
with sole responsibility according to Annex VII of the directive.
Ottobock | 13