Disposal; Legal Information; Liability; Trademarks - Ottobock BionicLink 60X3 Gebrauchsanweisung

INFORMATION
If the prosthesis is outside the transmitter's range or if the transmission path is shadowed (e.g.
by steel or reinforced concrete), the connection may be interrupted. This will be indicated by the
warning "connection interrupted" on the computer.

8 Disposal

In some jurisdictions it is not permissible to dispose of these products with unsorted
household waste. Disposal that is not in accordance with the regulations of your country
may have a detrimental impact on health and the environment. Please observe the
instructions of your national authority pertaining to return and collection.

9 Legal information

9.1 Liability

The manufacturer will only assume liability if the product is used in accordance with the descrip­
tions and instructions provided in this document. The manufacturer will not assume liability for
damage caused by disregard of this document, particularly due to improper use or unauthorised
modification of the product.

9.2 Trademarks

All product names mentioned in this document are subject without restriction to the respective
applicable trademark laws and are the property of the respective owners.
All brands, trade names or company names may be registered trademarks and are the property of
the respective owners.
Should trademarks used in this document fail to be explicitly identified as such, this does not justi­
fy the conclusion that the denotation in question is free of third-party rights.

9.3 CE Conformity

This product meets the requirements of the European Directive 93/42/EEC for medical devices.
This product has been classified as a class I device according to the classification criteria out­
lined in Annex IX of the directive. The declaration of conformity was therefore created by the man­
ufacturer with sole responsibility according to Annex VII of the directive.
This product meets the requirements of the European Directive 1999/5/EC for radio equipment
and telecommunications terminal equipment. The conformity assessment was drawn up by the
manufacturer in accordance with Annex IV of the directive.

9.4 Local Legal Information

Legal information that applies exclusively to specific countries is written in the official language
of the respective country of use in this chapter.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
20 | Ottobock