Correct Procedure For Demounting/Mounting Run Flat Tyres With Strap-On Sensor - TECO 100 Variant Betriebs- Und Wartungsanleitung

• Refit the valve sensor (if removed).
• Lubricate both tyre beads.
• Place the sensor at 5 or 6 o'clock.
• Set the tyre at an angle of about 45 degrees
• Turn the tyre so that it touches the mounting head and starts to be mounted on the rim.
• Rotate the tyre until the lower bead is mounted.
• Turn the sensor to 4 or 5 o'clock.
• Lower the bead breaker to allow a bead presser gripper to be inserted at 3 o'clock.
• Lower the bead breaking arm by about 5 cm (2 or 3 inches) to keep the upper bead of the tyre
inside the open centre during rotation.
• Rotate the tyre and make the necessary adjustments until the upper bead has been mounted.
• It may be useful to help the operation with a second Run-Flat gripper and/or the bead presser
accessory, if available.
• Using the bead breaker disc, remove the Run-Flat grippers used.
• Connect the inflation line to the valve for bead insertion.
CORRECT PROCEDURE FOR DEmOUNTING/mOUNTING
RUN FLAT TYRES WITH STRAP-ON SENSOR
NB: the sensor is at 180° to the tyre valve.
• Remove the valve plunger and let all the air out of the tyre.
• Visually inspect the actual position of the sensor that should be at 180°.
• Place the sensor at 3 o'clock (valve at 9 o'clock).
• Lower the bead breaker disc and start the rotational bead breaking stage.
• Lubricate the bead and continue rotational upper bead breaking until the sensor is at 12 o'clock
(valve at 6 o'clock) and not beyond.
• Raise the bead breaker disc.
• Move the sensor to 6 o'clock (valve at 12 o'clock).
• Push in the bead breaker disc and fit the gripper at 2 o'clock.
• Apply plenty of lubricant and break the lower bead.
• Move the gripper to 2 o'clock (sensor at 6 o'clock – valve at 12 o'clock).
• Position the demounting unit (tool head).
• Lower the swing tool to find the bead.
• Rotate clockwise so that the gripper is at 6 o'clock (sensor at 10 o'clock – valve at 4 o'clock).
• The bead is now engaged.
• Engage the bead with the demounting head.
• Rotate clockwise to demount the tyre, with the bead breaker disc in the down position.
• Remove the gripper.
• Now demount the tyre underside, taking care not to damage the sensor.
• Lubricate both tyre beads.
• Place the sensor at 2 or 3 o'clock (valve at 8 o'clock)
• Set the tyre at an angle of about 45 degrees
• Turn the tyre so that it touches the mounting head and starts to be mounted on the rim.
• Turn the tyre until the lower bead is mounted.
• Turn the sensor to 4 or 5 o'clock (valve at 10 o'clock).
• Lower the bead breaker to allow a bead presser gripper to be inserted at 3 o'clock.
• Lower the bead breaking arm by about 5 cm (2 or 3 inches) to keep the upper bead of the tyre
inside the open centre during rotation.
46
Tyre mounting (fig. 32)
Tyre demounting (fig. 32)
Tyre mounting (fig. 32)
User manual TECO 100 Variant