Standard Accessories; Rim Centring/Clamping Access.-Description And Use; Specified Conditions Of Use - TECO 100 Variant Betriebs- Und Wartungsanleitung

cannot be used reliably to establish whether or not further precautions are necessary. The factors
which determine the level of exposure to which the operator is subject to include the duration of the
exposure, the characteristics of the workplace, other sources of noise, etc. The permitted exposure
levels may also vary according to the country. However, this information will enable machine users
to make a more accurate assessment of hazard and risks.
5-101197........................................................................................ Locking pin (STANDARD version)
5-600357 ......................................................................................................Locking pin (AL version)
5-600358 ......................................................................................................Locking nut (AL version)
9005-101204 ........................................................................................................ Pin extension (Z1)
9004-103235 ............................................................................................................. Cone D58 (Z2)
9004-103234 ............................................................................................................. Cone D75 (Z3)
9004-103232 .........................................................................................Cone Protections D120 (Z4)
4-103235A ............................................................................................................... Cone D120 (Z5)
9004-103229 ........................................................................................................... Cone D145 (Z6)
5-690239 .............................................................................................................Plastic protections
9004-105142 .............................................................................................................Short help level
040000100....................................................................................................................... Brush (BR)
3-01523 ................................................................................................................Grease 4Kg (TG4)
RIm CENTRING/CLAmPING ACCESSORIES AND THEIR USE
For the diagram concerning optimal use of the centring and clamping accessories depending
on rim type, see fig. 36 onward.
The tyre changer has been designed exclusively for mounting and demounting tyres, using the tools
the machines are equipped with, following the instructions in this manual.
WARNING
Any other operation carried out on the machine is considered as improper use and shall be
construed as negligence.
These machines are equipped with an inflation system independent from any other function described
above. Take great care when using it (read the INFLATION chapter).
WARNING
The use of equipment other than genuine accessories when operating the machine is not re-
commended.
The operator's position during the different operating stages is shown in fig. 8.
WARNING
Keep hands well away from machine moving parts.
WARNING
To stop the machine in an emergency:
- disconnect the power supply plug;
- isolate the compressed air supply network by disconnecting the (quick-coupling) shut-off
valve (fig. 6).
User Manual TECO 100 Variant

STANDARD ACCESSORIES

SPECIFIED CONDITIONS OF USE

37