Operation Guide; Engaging The Cot Into The Fastener - Stryker Power-PRO TL Bedienungs- Und Wartungshandbuch

ENGAGING THE COT INTO THE FASTENER

1. Before attempting to engage the cot into the fastener,
ensure that the pedal is fully depressed and the
cot is completely lowered as shown in Figure 14.
2. Guide the cot into both the head end and foot
end portions of the fastener until the locking
mechanism is engaged as shown in Figure 15.
3. Check to be sure the cot is securely fastened at both
the head end and foot end before releasing your grip
on the cot as shown in Figure 16.
CAUTION
• The unit must be in its fully down position to properly
engage the cot fastener (not included).
• To ensure that the cot is in the lowest position,
press the retract (-) button until the cot stops moving
downward. This should be done prior to attempting
to engage the cot into the cot fastener (not included).
• To reduce risk of damage to the cot or cot fastener,
do not attempt to activate the cot height activation
while it is engaged in the cot fastener (not included).
www.stryker.com

Operation Guide

Figure 15 - Cot in Fastener - (Foot End)
Figure 16 - Cot in Fastener (Head End)
6385-009-005 REV B
Figure 14 - Pedal fully depressed
Return To Table of Contents
English
1-19