Stryker Power-PRO TL Bedienungs- Und Wartungshandbuch Seite 14

English
HEAD END AND FOOT END FASTENER INSTALLATION (MODEL 6386 AND 6387) - CONTINUED
INSTALL BOTH FASTENERS - CONTINUED
6. Repeat steps 2 - 5 to install the head end fastener to the floor track (Figure 7).
Foot End Fastener
Foot End
7. Confirm fastener spacing as shown in Figure 8.
Foot End
8. Adjust the track mounted fasteners (Unwin adaptors), as needed to fit into the tracks, by loosening the four screws
on either side of the fastener that attach the locks to the lock down base plate.
9. Retighten the screws after aligning the locks with the tracks.
Track mounted fastener (Unwin adaptor) supplied by Unwin Safety Systems.
Return To Table of Contents
1-14
Cot Fastener Installation
Head End Fastener
Figure 7: Head End and Foot End Fastener - Floor Track Installation
Figure 8: Fastener Spacing
6385-009-005 REV B
948 MM
Head End
Head End
www.stryker.com